Extend the life of forklift clutch

In response to these problems, also experimenting with the bearing grease on the heat inside, the grease soaked into the bearing, so that after treatment, although can be filled with bearing grease, but because the grease structure by heat treatment after the destruction of a large performance reduce the rate of using this method is not ideal, does not extend bearing life. We have to use the tip of the release bearing grease gun nozzle direct injection butter. And then installed on the

Lpg Gas Forklift Truck

, has been observed to detect, bearing life greatly extended. The oiling method has received satisfactory results, but the operation is more complicated. Then explore the disintegration of the engine is not the case, add butter, first try to succeed in the 475C engines, and then type in the 475C and 480,492 engines a trial, both received very good results. After repeated practice, improvements, lessons learned, and ultimately the formation of a relatively simple method of operation oiling procedure is as follows:

(L) without disassembly of the engine oiling method first open clutch cover, release bearing wear concept check, if the confirmation is not damaged or worn bearing no overrun, remove the clutch pedal, adjust the rod axis pin bearing and the separation seat back to the last position, the bearing bore butter filling with beak grease gun until the bearing oil spill, and then a little bit of rotation bearings, grease again, repeat the above work, a little butter until around the bearing has overflowed again bearing rotation, observe oil, bearing rotation if they feel there is resistance, that they have filled in the bearing grease. Then clear separation bearing throughout spilled a small amount of butter, to remove the pin and the clutch cover, such as re-assembled.

(2) engine disintegration oiling method exposed engine disintegration release bearings and bearing assemblies, to separate the bottom of the bearing inner ring with a small hole refueling beak grease gun, bearing grease overflow when rotating bearing until the bearing of a circle overflow can have butter.

After processing the above two methods, within six months the release bearing can no longer refuel. The oiling method Wheel Driving Diesel Forklift station after the trial, significantly improve the mechanical integrity, and achieved significant economic benefits. Material cost savings; improve handling amount each month can increase handling capacity 30t. This method also in the promotion of other railway stations too, have achieved better results.